www.pexels.com ```html Introduction: DIY Planer Boards for Trolling
Planer boards are essential tools for anglers who want to cover a wider area while trolling. They allow you to spread your lines out away from the boat, preventing tangles and increasing your chances of catching fish. Commercial planer boards can be expensive, but building your own is a relatively simple and cost-effective project. This guide will walk you through the steps to create your own planer boards.
Materials You'll Need
- High-density polyethylene (HDPE) sheet (approximately 1/2 inch thick)
- Eye bolts (2 per board)
- Nuts and washers for eye bolts
- Release clips (2 per board)
- Wood screws (stainless steel recommended)
- Closed-cell foam (for flotation)
- Reflective tape (optional, for visibility)
- Paint or sealant (optional, for protection)
Tools You'll Need
- Saw (circular saw, jigsaw, or table saw)
- Drill with various drill bits
- Screwdriver
- Measuring tape or ruler
- Pencil or marker
- Sandpaper or file
- Wrench
Step-by-Step Instructions: Building Your Planer Boards
Cut the HDPE sheet into the desired shape. A common size is around 12-18 inches long and 6-8 inches wide. A rectangular shape with a slight angle on the leading edge is a good starting point. Use a saw to make clean, straight cuts.
Use sandpaper or a file to smooth all the edges of the HDPE. This will prevent sharp edges that could damage your fishing line or injure you.
Drill holes for the eye bolts. One eye bolt will be near the front of the board (closer to the boat), and the other will be further back. The placement is critical for proper board tracking. Measure and mark the locations carefully. The front eye bolt should be slightly off-center towards the side away from the boat (outside edge).
Insert the eye bolts into the drilled holes and secure them with nuts and washers. Make sure the eye bolts are tight but not overtightened, as this could crack the HDPE.
Attach the release clips to the eye bolts. These clips will hold your fishing line and release it when a fish strikes. There are various types of release clips available; choose ones that are suitable for the type of fishing you'll be doing.
If desired, attach closed-cell foam to the top or sides of the planer board for added flotation. This is especially helpful if you are using heavier lures or trolling at slower speeds. Use wood screws to secure the foam to the HDPE.
Apply reflective tape to the planer boards for increased visibility, especially in low-light conditions or at night. This can help prevent collisions with other boats.
Paint or seal the HDPE to protect it from the elements and give it a more finished look. Use a paint or sealant that is designed for use on plastics.
Conclusion: Enjoy Your DIY Planer Boards
Congratulations! You've now built your own planer boards. Remember to test them in a controlled environment before using them in a real fishing situation. Adjust the placement of the eye bolts or the amount of weight on the boards if necessary to achieve the desired tracking. With a little practice, you'll be able to effectively use your DIY planer boards to catch more fish. Tight lines!
``` Cabin Cruiser Boats
www.discoverboating.com Boating Guide, Find Your Dream Boat
www.discoverboating.com 1000+ Amazing Boat Photos · Pexels · Free Stock Photos
www.pexels.com
0 komentar:
Posting Komentar